This Standard covers malleable iron threaded fittings, Classes 150 and 300. It also contains provisions for using steel for caps and couplings in Class 150 for NPS 3/8 and smaller. This standard includes: (a) pressure-temperature ratings (b) size and method of designating openings of reducing fittings (c) marking (d) material (e) dimensions and tolerances (f)…
This Standard establishes uniform practices for reporting attribute or variable measurement data for the dimensioning and tolerancing specifications defined in ASME Y14.5-2018 and actual values defined in ASME Y14.5.1-2019. This Standard may be used with previous versions of ASME Y14.5 where they do not conflict with ASME Y14.5-2018. Measurement data used in support of product…
ASME B30.5 is one of ASME’s most requested safety standards widely respected and applied throughout the building and construction industry. It addresses crawler cranes, locomotive cranes, wheel-mounted cranes, and any variations thereof that retain the same fundamental characteristics and are powered by internal combustion engines or electric motors. The scope of this Safety Standard includes…
Within the general scope defined in B30 Standard Introduction, Section I, ASME B30.23 may apply to hoisting and accessory equipment covered within certain volumes of the ASME B30 Standard, which is used to lift, lower, hold, or transport personnel in a platform, by wire rope or chain, from hoist equipment, or by a platform that…
ASME has been defining piping safety since 1922. ASME B31.3 contains requirements for piping typically found in petroleum refineries; chemical, pharmaceutical, textile, paper, semiconductor, and cryogenic plants; and related processing plants and terminals. It covers materials and components, design, fabrication, assembly, erection, examination, inspection, and testing of piping. This Code applies to piping for all…
Sets forth requirements for the establishment and execution of quality assurance programs for the siting, design, construction, operation, and decommissioning of nuclear facilities.
This Standard applies to stationary reinforced thermoset plastic corrosion resistant vessels used for the storage, accumulation, or processing of corrosive or other substances at pressures not exceeding 15 psig external and/or 15 psig internal above any hydrostatic head.
This Standard establishes safety requirements for powered platforms (scaffolds) for buildings where window cleaning and related services are accomplished by means of suspended equipment at heights in excess of 35 ft (11 m) above a safe surface (e.g., grade, street, floor, or roof level). Additionally, this Standard establishes safety requirements for permanent traveling ladders and…
Example problems illustrating the use of the design-by-rule methods in ASME B&PV Code, Section VIII, Division 1 are provided in this document. Example problems are provided for most of the calculation procedures in either SI or US Customary units.
No products in the cart.